My Cart (0) - 
Coat floors with more floor finish on a wax applicator mop. Slow down the stroke as the finish is laid on the floor. Use a…
Apply even and full coats of wax/floor finish, allowing each coat to dry properly and completely before applying another layer. Pour less solution into your wax applicator mop, or…
Double scrub with an automatic walk behind scrubber, making sure to remove all solution off of the floor, then recoat, and burnish repeatedly. Use a clean burnishing pad. If that does not work, strip the old wax off following…
Vacuum up as much stripper left on the floor after stripping as possible. Rinse thoroughly with neutral cleaner in the auto scrubber. A “hot” floor – too alkaline or too acidic – can cause finish to discolor. Use clear clean water to trim and…
Change pad, flip to clean side, or clean pad by running under a continuous stream of warm water. It also important to dust mop and sweep up all debris before polishing your floor. This eliminates unnecessary build up from dirt and debris inside…
