| |
|
|
|
|
 |
Problem: Finish Swirls or Scratches in Floor Wax
|
| |
|
| |
Cause: Pad too aggressive
Solution: Use the recommended floor stripping pad for the task being performed, or move to a pad that is less abrasive.
Cause: Dirty pad
Solution: Change pad, flip to clean side, or clean pad by running under a continuous stream of warm water. It also important to dust mop and sweep up all debris before polishing your floor. This eliminates unnecessary build up from dirt and debris inside your pad, making each pad last longer.
Cause: Floor dirty or sandy
Solution: Use and maintain walk-off mats. Dust mop the floor thoroughly before and after burnishing. Walk off mats can capture up to 85% of all dirt, debris and moisture that enters a facility.
Cause: Restorer not properly diluted
Solution: Check floor restorer dispenser dilution tip for accuracy. Follow label directions regarding proper product usage and dilution.
Cause: Finish not completely dry before burnishing
Solution: Allow more time for finish to dry in between coats.
Cause: Too much pad pressure
Solution: Do not place additional weight on the deck. Do not lift up on the handle when burnishing. This can put unnecessary pressure down causing your pad to dig down deeply into the floor finish.
|
| |
|
| |
Other Possible Floor Finish Problems:
· Floor Finish Discoloration (yellowing or browning)
· Poor Gloss to Floor Finish Wax
· Slippery Floors
· Sticky or Tacky Floor Finish
· Streaks in Floor Finish |
| |
|
|
 |
|
|