| Order Floor Finish Mops, Handles, & Wax online or give us a call at 1-888-722-5508 |
 |
 |
|
|
|
|
| #7 - Applying Floor Finish Procedure |
|
|
| |
|
#7 - Applying Floor Finish Purpose: To protect floor surfaces, and to maintain clean, safe, attractive floors.
Required Supplies & Equipment:
· Mop Bucket & Wringer
· Set of Wet Floor Signs
· Floor Finish
· Clean Floor Finish Wax Applicator Mops
1. Prepare Equipment - To save clean-up time,
line the mop bucket with a new plastic trash can liner bag.
2. Inspect Floor - Make sure that the floor
is thoroughly dry and clean.
3. Prepare Area - Set up "Caution"
signs in public areas. Avoid blocking doors whenever
possible. Place doorway mats at entrances.
4. Apply First Coat of Seal - Start by pouring
the floor finish into the lined mop bucket and place a
clean non rusty wringer into the bucket. Take the
clean mop and immerse the mop in the finish. Wring
the mop out slightly; to eliminate dripping. Apply
a THIN coat of finish to the floor. Start applying
the floor finish by running the floor finish applicator mop parallel to
and next to the baseboard. Do not apply finish to
the vertical portions of baseboards and walls. Form
a "U" shape section of applied finish, then cover the remaining floor area, inside the "U"
using the "figure 8" stroke. Use additional
finish as needed. Be sure to cover the entire floor.
Avoid splashing the floor finish. Allow finish to dry completely, before applying another coat.
5. Apply Second Coat of Seal - Repeat the
above instructions. You may wish to avoid building
up edges by keeping a few inches away from the baseboards.
Apply a THIN coat of finish. This second application
should be made using the "figure 8" pattern
which reduces back fatigue. Allow second coat to
dry completely.
6. Additional Coats - Repeat the above instructions
using the same floor finish for the next two and all subsequent coats.
More coats allow more protection for the floor and
a better appearance.
If a high speed burnishing program is used, apply
at least two coats of finish over the seal.
Let the floor dry as long as possible before opening
to traffic.
7. Clean Up - Immediately clean up equipment
after the procedure. Wash, rinse and dry buckets
and wringers. Hang mops to dry, away from walls.
Other equipment is either washed or wiped down and
stored in the proper location. Wash hands.
*All info courtesy of International
Sanitary Supply Association, Inc. ©2002.
|
|
|
|
|
|
|
Search by Product at CleanFreak.com
|
|
|
|
|
|
|
FREE with $1000.00 orders!!
Floor Bucket & Mop Wringer Package
(1 mop bucket & wringer, 1 mop handle, 2 mops, 1 qt. of Blue Clean SC w/ proportioner, & 2 wet floor signs)
Regular Price: $151.13
Sale Price: $109.40
Package Price: $85.66
(You receive 2 FREE mops & 1 qt. of Blue Clean SC w/ proportioner, worth $23.74) |
FREE Floor Polishing Chemical!!
Sale Price: $846.30
Commercial Floor Burnishing Package
(20" Burnisher, 2 cases of green mint polishing pads, & 3 cases of floor restorer)
Regular Price: $1424.44
Sale Price: $924.54
Package Price: $846.30
(You receive 3 FREE cases of a floor restorer, worth $78.24!) |
|
|
|
|
|
|
|
