This warm up spray nozzle has a number of uses and can be used with any of our box carpet extractors that have a male quick disconnect coming off of the solution hose. Here is a list of various uses for this tool;
- It can be used as water recycling tool to heat up the water in your extractor as you prepare the area that needs to cleaned. Simply attach it to the solution line and place in the solution tank. Then turn on the pump, and once the water starts to flow, turn on the heater.
- It can be used as a pre-spray tool to spray down the carpeted areas before you attempt to clean them. This gives the solution a chance to do it's job before it is worked in further or recovered.
- It can be used to empty out your solution tank. We don't recommend this if there is a lot of solution left in the tank, as this can put unnecessary stress on the pump of your machine. It is much more efficient to use the recovery hose and suck out all the unused solution.
- Last but not least, it can be used to prime your pump. First place this fitting on the end of your solution line. Then stick this nozzle into the end of the vacuum hose and create as much of a seal as possible by filling the remaining area with a rag. Once you have accomplished these tasks, simply switch on the vacuum and pump switches, and the air that is locked into the pump should be sucked out. (*Please Note: Do not allow your rag to be sucked completely up by the vacuum hose.) We have a much more handy tool available, which is called our Carpet Extractor Pump Priming Hose, but this nozzle will work as well.
|Quantity Per Carton||1|
|Internal Search Number||105415|