The Misco MPC Maintenance Solutions Hot Shot Heavy Duty No Rinse Speed Stripper that is safe for use on vinyl tile, terrazzo, concrete, ceramic tile, flagstone, and linoleum floors. This is a very effective floor stripping chemical that can emulsify any aged and built up finish almost instantly. Can be used as a no scrub stripper, or with some of our stripping pads on one of our rotary floor scrubbing buffers or our automatic walk behind scrubbers. Either one of these machines will greatly increase the amount of floor finish that is removed due to agitation. The more concentrated the solution (can be mixed from 1:2 to 1:11), and the more aggressive the pad, the more finish that will be removed.
Directions: 1.) We recommend taking a look at our resource center first, and reading through our floor stripping procedures & instructions for the best ways to properly strip a floor. 2.) Dust mop the floor following our dust mopping procedures. 3.) Dilute low odor floor finish stripping chemical from 1:2 to 1:11 (1 gallon of stripper with 2 to 11 gallons of water) with cold or warm water, depending on age and build-up of finish. The more water added, the less powerful the solution will be at removing built up finish. Do not use hot water. 4.) Liberally apply the mixed solution across the entire area, and do not allow the solution to dry. 5.) Allow the solution to dwell for 3 to 5 minutes. 6.) Agitate the applied solution with one of our mops, rotary buffers or auto scrubbers. 7.) Pick up the laid down solution with one of the wet pick up vacuums or auto scrubbers we have to offer. 8.) Rinse floor with clean water and recover that rinsed solution. 9.) Clean out all mops, machinery, and buckets to eliminate any left over stripping residue.
*Please Note: As always, we recommend testing this product in an inconspicuous area before applying to larger areas.