| |
|
|
|
|
| Specialty Chemicals > Certified Protect-O Carpet Stain Sealer |
| |
Order Online or Call 1.888.722.5508 |
Ordering Information: |
|
|
|
|
| Certified Protect-O Carpet Stain Sealer |
|
|
|
| Product Information: |
|
Certified Protect-O Carpet Fiber Guard
(4 gallons per case)
· Protects carpet and furniture fabric from spills and accidents
Regular Price: $173.12
Sale Price: $127.30
Click here for a copy of the Protect-O Fiber Guard MSDS Sheet.
Certified Protect-O is a water-based carpet protective chemical that provides an invisible, protective shield for new or just cleaned carpet and upholstery. Make your carpets resistant to oily spills and wet or dry soil. Spills can than be removed before they soak into the carpet fiber. Treated carpeting will last longer, clean easier, and look better between cleaning with regular vacuuming and prompt attention to spills. Solvent free and safe. Dries quickly with no unpleasant odors.
This product can be found in our specialty carpet chemicals category, just like its sister product, Nyco's carpet, upholstery & fabric protectant.
Directions for Use:
1.) Use Protect-O on new or just cleaned carpet. Any soil or fiber will be sealed into the carpeting once applied. Make sure carpet is clean!
2.) For damp (just cleaned) carpet, dilute 1 gallon of fiber guard with 2 gallons of water for application on 1,000 square feet of average carpet. For dry or dried carpets, dilute 1 gallon fiber guard with 4 gallons of water for application on 1,000 square feet of normal carpet.
3.) Use one of our pump-up chemical sprayers to dispense solution. Apply horizontally and vertically in two passes to ensure uniform coverage.
4.) Brush into nap lightly, finishing by brushing nap in one direction.
5.) Use furniture protectors, or wax paper, under legs on damp carpet.
6.) Wipe off any Protect-O sprayed on walls, molding, furniture legs, wood, or painted surfaces immediately.
7.) Rinse out and thoroughly cleanse all spray equipment after use.
8.) Test for adequate and uniform application of fiber guard by spilling a few drops of water over several places of treated and dried carpet. The water should bead up and remain on the surface. If it soaks into the fabric, additional application is needed.
Care of Treated Carpets:
Vacuum or use our Certified Pile Brush for normal maintenance. If spills occur, they can normally be mopped up before they soak in and cause a stain. If a spot or stain must be cleaned, first
carpet bonnet, then do a hot water extract, or just extract the entire area. Next apply the fiber guard over the cleaned area. |
|
|
|
|
|
